This is just the beginning.

Here’s to embracing
your power.
your era.
within. 

Video
Alt image Alt image Alt image

Unlimited personalization.
Infinite results. 

2 modes

5 intensities

all areas

One intelligent device that adapts to you — not the other way around

2 modes

Tighten

Firm, smooth, and refine skin texture for long-term visible results — 10 mins.

Energies Active:

Radio Frequency
(high strength)

650nm Laser

Sculpt

Lift and tone facial contours for an energized, radiant look for 6 mins

Energies Active:

Radio Frequency
(low strength)

Microcurrent

Red Light

designed for

all areas

from face to neck and beyond.

01.

Cleanse

Remove all makeup and thoroughly cleanse your face.

02.

Apply Skincare Glide

Apply a water-based serum or gel to your skin or the device head to ensure optimal microcurrent energy flow and smooth gliding.

Can be used over a sheet mask, though energy output may be reduced.

Reapply if dryness or resistance occurs.

Avoid oils or thick creams, as they can interfere with performance.

03.

Ritual

Turn On

Press and hold the Power / Mode button for 3 seconds to turn on the device

Switch Modes

Short press the Power / Mode button to switch between modes.

Adjust Intensity

Use the + / – buttons to adjust intensity (Levels 1–5, indicated by 1–5 lights).

Pressure & Speed Guidelines

Apply light to moderate pressure and glide at approximately 1–2 cm per second — enough for full contact, but without indenting the skin.

Treatment Timing & Beeps

 A single beep every 2 minutes reminds you to move to the next treatment area.

Two beeps indicate the end of the current mode; the device will enter standby.

To start another mode, short press the ‘Power / Mode’ button and repeat.

Turn Off

Press and hold the Power / Mode button for 3 seconds to power off the device.

Glide with purpose. 
Repeat with care. 
Always lift.

*Tip: The device pauses Radio Frequency when still - motion activates energy flow.

How often to use?

Recommended Usage: 2–4 sessions per week, with a minimum 24-hour interval for skin rest.

 

Treatment Time: 6–16 minutes per session. 

 

'Sculpt Mode' runs for 6 minutes; 'Tighten Mode' runs for 10 minutes.

 

You may use one mode only or treat the same area (e.g., lower face, full face, or neck) with both modes sequentially in a single session, depending on your treatment goals.

 

The Results:

•Instant: A lifted, refreshed look immediately after use.

•Long-term: In an independent study, users experienced visible lifting, smoothing, and firming within 4 weeks. While individual results vary, early improvements are often observed within 2 weeks.

 

The Ritual: 

Consistency is the catalyst. We recommend committing to 3+ sessions weekly to build your foundation. 

 

After 28 days, you define the pace: continue for momentum, or switch to maintenance (1–2 sessions weekly).

Is one mode meant to treat one area, half the face, or the full face?

The time allocated for each mode refers to the total treatment time, not per side.

 

You can use that time across:

 

• The full face (moving areas at each 2-minute beep)

• Half the face

• One targeted area (e.g., jawline or nasolabial folds)

 

For example, Sculpt Mode is 6 minutes total. You might treat:

• 2 mins forehead

• 2 mins right cheek

• 2 mins left cheek

 

Or dedicate the full 6 minutes to one focused area.

 

The choice depends on your treatment goal.

Can I use two modes on the same area in one session?

Yes. You can use both modes on the same area in a single session. 

 

We recommend:

•Sculpt first (radiance and lift)

•Then Tighten (visible firming)

 

Just keep your total session under 30 minutes and allow at least 24 hours between Tighten sessions.

What skincare products should I use with theBeam?

Use any water-based skincare product, this helps conduct the energy evenly and ensures smooth glide. 

 

A few options we recommend: 

• Hyaluronic acid serum (deep hydration and conductivity) 

• A hydrating sheet mask (great for comfort and glow) 

• Water-based lotion (as long as it’s not too thick or oily) 

• Pure aloe vera gel (light and soothing) 

 

Avoid creams or oils, as they block the Microcurrent and Radio Frequency (RF). 

 

If you’re ever unsure, just check the first ingredient — if it’s water (aqua), it’s usually perfect.

What sensations are normal during treatment?

Gentle warmth

Yes — this is expected. Continue treatment.

 

Mild tingling or pulsing

Yes — this indicates Microcurrent energy conduction. Ensure skin is well hydrated.

 

Sharp or “zapping” sensation

No — add more skincare products and/or reduce intensity.

 

Burning sensation

No — stop immediately and contact support.

 

Treatments should feel warm and active, not painful.

How hot should the device feel during treatment?

Some users expect strong surface heat. However, theBeam is capped at 42°C for controlled dermal heating — not surface overheating. So it should feel like a warm stone facial.

 

Its effectiveness comes from RF energy heating the 3.5mm dermal layer for visible firming results, rather than aggressively heating the skin surface.

 

If the warmth feels mild, this can be normal. The sensation may be softer because:

• A thicker gel layer buffers surface sensation

• Well-hydrated skin conducts energy efficiently

• Continuous movement distributes heat evenly

• Cooler room temperatures reduce perceived warmth

• The battery level is low

 

Heat builds progressively over several minutes.

How should I take care theBeam after use?

After Using: Turn off the device. Rinse it gently and quickly, then dry with a soft cloth. You can also wipe off any skincare products left on the device. Avoid using abrasive materials or harsh chemicals, as they can damage the device.

Storing: Allow the device to dry completely before storing it in a cool, dry place away from sunlight.

Can I use it on my neck or body?

Yes. theBeam can be used on the neck, jowls, and body areas like the stomach, thighs, or hands.

 

Its flat sapphire head and eight titanium electrodes ensure full-surface contact and even energy distribution, supporting visibly firmer-looking skin safely across larger areas.

 

For the neck:

• Avoid the centre of the throat (thyroid area)

• Focus on the sides of the neck and under the jawline

• Use upward gliding motions

 

For body areas (e.g., stomach, thighs, hands):

• Use a generous amount of gel

• Move slowly and maintain full contact

When should I NOT use theBeam?

Do not use theBeam if you:

• Are pregnant

• Have a pacemaker or implanted electronic device

• Have metal implants in the treatment area

• Have active skin infections, open wounds, or severe inflammation

• Have uncontrolled medical conditions affecting the skin

• Have recently had injectables (wait 2 weeks)

 

Avoid using over:

• The centre of the throat (thyroid area)

• Broken or irritated skin

• Areas with active eczema, psoriasis flare, or sunburn

 

If you are under medical supervision or unsure about a specific condition, consult your healthcare professional before use.

 

When in doubt, pause treatment and contact support.

Is it safe to use if I have Botox or Fillers?

Yes, theBeam is a great complement to clinical injectables. While injectables address volume and movement, theBeam helps improve the appearance of skin firmness and texture.

 

The Protocol: 

We recommend waiting 2 weeks after any injection to allow the product to settle perfectly.

 

Pro Tip: 

You can continue to use the device on untreated areas.

How to charge theBeam and check the battery level?

charging

To Charge: Set the device on the charging base when the power light is on. The battery lights on the device will blink while it charges.

Fully Charged: The battery lights stop blinking when the battery is full.

*Note: Don’t use the device while it’s charging.

checking battery level

While Using: You can’t check the battery level.

In Standby: Turn on the device to see the battery level. Five lights mean the battery is full; one light means it’s low.

low battery warning

When On or in Standby: The battery lights will keep blinking.

When Off: Pressing the ‘Power / Mode’ button won’t turn on the device if the battery is low; the first light blinks five times and then turns off.

How often should I charge the device?

A full charge supports approximately 4–8 full sessions, depending on intensity and session durations. Recharge when the battery drops to 1–2 lights for optimal performance.

 

When the battery is very low, energy delivery may feel weaker. For consistent performance, use the device with at least 2–3 battery lights remaining.

Can I travel with theBeam?

Yes. The device contains a lithium battery.

 

• Carry-on luggage: Yes (recommended)

• Checked luggage: Not recommended due to airline regulations

 

Always confirm with your airline when travelling internationally.
Alt image Alt image Alt image

Your 28-Day
Renewal Journey

Your 28-day renewal journey

Consistency is the catalyst. Commit to 3+ sessions weekly to build your foundation. After 28 days, you define the pace: momentum or maintenance.

Day 1

Instant Revitalization

The first 10 minutes change everything. Fluid drainage and boosted micro-circulation deliver a subtle, instant lift to your brows and jawline. 

 

You emerge from your ritual looking luminous and beautifully refreshed.

Day 28

Visible Transformation

The change becomes structural. Your skin feels denser, clearer, and more resilient.

 

This is the phase where friends tell you that you look incredible, but they can't quite pinpoint exactly what has changed.

2 Months

Sustained Definition

Now, the results are part of you. Your jawline looks reclaimed and your skin carries a youthful "bounce" that stays. 

 

You have sculpted your features while protecting the natural volume that defines your beauty. 

4 Professional Synergies.
1 System.

The world's first system to unite 15W High-Power RF with Bio-Mimetic Microcurrent, Laser, and Red Light. 

It targets every layer of the skin simultaneously — for visibly firmer-looking skin, an energized complexion, and toned contours in a single session.

15W & 5.3MHz RF - Firm

200µA Microcurrent - Tone

650nm Laser - Renew

630nm Red Light - Calm

The 'skin clinic in your hands'

SHOP NOW

Curated skin science, expert tutorials, and member-only privileges.

About

About Us

FAQs

Tutorials

Contact Us

Care

Warranty

Returns

Social

Instagram

Facebook

Designed in Australia

© 2026